Mara Tape Manufacturer: Application and Characteristics of High Temperature Tape

　　Marla tape manufacturers: High temperature tape is also called high temperature resistant tape, that is, tape used in high temperature operating environments. Mainly used in the electronics industry, the temperature performance is usually between 120 degrees and 260 degrees, commonly used in paint, paint leather processing, coating shielding and electronic parts fixing process, printed circuit board and high temperature processing shielding.

Mara tape manufacturers: application and characteristics of high temperature tape.

Mara Tape Manufacturer: High temperature tape has high and low temperature resistance; Corrosion resistance; Low friction and good wear resistance; It has the advantages of moisture resistance and high insulation. At the time of production, there will be a lot of high temperature tape problems. Daily use is to wipe with a small amount of clean water with a cotton cloth. So how to fundamentally solve this problem?

Mara tape manufacturers: in view of this phenomenon, the key is to control the quality of high temperature resistant tape suppliers. We should pay attention to screening and testing in the supply link, so that we can control the raw materials. If the phenomenon of residual glue is found in the production process of the production line, the abnormal workpiece should be taken out and stored separately immediately. At the same time, increase the inspection of network products. Solve problems in the production process.

Mara tape manufacturers: according to the actual situation, the production process of defective products for analysis, until the root of the problem. Only fundamentally can we solve the common problem of high temperature tape. How to properly store high temperature tape?

(1) The tape should be stored in the warehouse to avoid sun and rain; it is strictly prohibited to contact with acid, alkali, oil and organic solvents, keep it clean and dry, 1m away from the device, and the room temperature is between -15 ℃ and 40 ℃.

(2) The tape should be placed in a roll and not folded. If it is stored for a long time, it should be turned over once a quarter.

(3) Mara tape manufacturer tells you that when loading and unloading the conveyor belt, use a crane and a beam sling to lift it smoothly to avoid damaging the edge of the conveyor belt. Do not load and unload at will to avoid loosening and swinging of the sleeve.

(4) The type and specification of the tape should be reasonably selected according to the use needs and specific conditions.

(5) It is not allowed to connect tapes of different varieties, specifications, strength and cloth layers together.

(6) The conveyor belt joints are thermally vulcanized and bonded to improve reliability and maintain high effective strength.

(7) The diameter of the conveyor roller and the diameter of the belt wheel of the conveyor belt shall comply with the relevant regulations.

(8) The tape shall not be serpentine or creeping, and the drag roller and vertical roller shall be flexible and the tension shall be moderate.

(9) Marla tape manufacturers tell you that when the conveyor is equipped with baffles and installation devices, the wear of the belt should be avoided.

(10) cleanliness is the basic condition for good operation of the tape. Impurities will affect belt eccentricity, tension difference, and even fracture.

　　(11)Marla tape manufacturersTell you if the early found that the tape is damaged, should be found in a timely manner, timely repair, to avoid adverse consequences.